During the operation of the sharp road mixer, some unexpected problems will inevitably occur, and everyone should encounter some similar problems in actual operation. For example, after a long period of operation, if it is not cleaned in time, the mixer is likely to cause blockages. If it is not found in time, it will have an impact on the use of the machine. So what should I do if the Rima mixer parts are blocked? Let's find out together.

First of all, when inspecting along the pipeline, you can use a small hammer to lightly hit the part that is considered to be blocked. Sometimes the blocked aggregate can be disintegrated to restore unblocking: if the tap is not effective, you should not use a hammer or other possible damage to the pipeline. Smashed the object.

If the blockage is judged accurately, and the blockage is not far from the discharge end of the pipeline, just remove the blockage in the blockage section, remove the blocked concrete, and then install it again to continue pumping.

The blocked pipe part is easy to judge when the pipe is disassembled; as long as the pumping operation is performed, and there is engineering material flowing out of the disassembled pipe, it means that there is no blockage between the disassembled part and the mixer, and the inspection should be continued until the blocked place is found. If the plugged part is far away from the pipe end, the plugged section will be cleaned and reinstalled in the pipe. Due to the air plug effect of this empty pipe, it will cause a blockage again. In this case, the pipeline concrete after the blockage section should be blown out with compressed air and then taken over for pumping. The road mixer can only react in time when there is a problem when it is explored and understood in actual operation, which is helpful to the machine itself and the work efficiency.